Aerotech Ensemble Epaq - Table 2-1: Main AC Power Input Voltages and Current Requirements

Installation and Configuration Ensemble Epaq Hardware Manual
Table 2-1: Main ACPower Input Voltages and Current Requirements
ACInput Voltage Input Amps (maximum continuous)
100 VAC 50/60 Hz 10 Amps
120 VAC 50/60 Hz 10 Amps
200 VAC 50/60 Hz 6 Amps
230 VAC 50/60 Hz 5 Amps
The AC power cord/wiring to the Epaq must be rated for at least 300 V and have a minimum current capacity
of 10 amps. The insulation rating for the AC power wiring must be appropriately rated for the environment.
The temperature rating of the insulation must be at least 80ºC. Environmental conditions may necessitate
the need to meet additional AC wiring requirements or specifications. AC wiring should not be bundled with
signal wiring to minimize EMI coupling and interference.
D A N G E R : See the user documentation provided with your Ensemble Epaq system to
determine if the Ensemble Epaq chassis is limited to only one AC input voltage. Operation at
other voltages may result in damage to the Ensemble Epaq chassis.
www.aerotech.com Chapter 2 19