Aerotech Ensemble Epaq - Brake Output; Table 2-16: Brake Output Pin Assignment

Ensemble Epaq Hardware Manual Installation and Configuration
2.3.6. Brake Output
The Brake Output pins provide a direct connection to the solid state relay on the Epaq. The brake output pins
permit the brake to be wired with other signals in the feedback cable. The brake is configured for automatic or
manual control using controller parameters (refer to the EnsembleHelp file for more information).
Refer to Section 3.2. for more information on using the brake output with the solid state relay.
Table 2-16: Brake Output Pin Assignment
Pin# Description In/Out/Bi
13 Optional Brake - Output Output
25 Optional Brake +Output Output
46 Chapter 2 www.aerotech.com