12
User Interface Overview
Test Pages Tabs Legend
1. Home - display OTDR setup, change Fiber and Cable ID parameters.
2. Test Settings - dene OTDR test setup.
3. Event Settings - dene OTDR Event settings and Pass/Fail settings.
4. Job Settings* - review current job settings.
DFS Test Mode is optional (see page 4 for details)
* The Job Settings tab is included in each test mode as a convenience. Current Job settings can
also be viewed and changed using the New Job tool accessed from the Main Menu.
1. Home - display OPM setup; shows Live power or loss readings.
2. Loss Table - review results saved for the current cable.
3. Job Settings* - review current job settings.
1. Home Page - activate Live DFS mode and capture the displayed ber end-face image.
2. Results page - display captured end-face image; shows saved image of current ber or from
Results Manager.
3. Job Settings* - review current job settings.
When a test mode (OTDR or OPM) is enabled, your OTDR will display the ‘Home’ screen of the
enabled test mode.
• Use Tab keys
to change test pages/screens available for the enabled test mode.
Full Auto/Expert OTDR mode
1 2 3 4
Real-Time OTDR mode
1 2 4
OPM mode
1 2 3
DFS mode
1 2 3
To Next Page
Loading...
Need help?
General
