22
In Expert mode only: Auto is the default
setting. Use
arrows to toggle between
the Auto or Off options.
Use arrows to toggle between the On/
Enabled or Off/Disabled options.
Expert and Full Auto modes only:
Use arrows to toggle between the On/
Enabled or Off/Disabled options.
In Expert mode only: Use arrows
to select the Default or User option. If
set to User, press
key to display editor
submenu, which allows dening the
Threshold parameters.
Use arrows to select the Default or
User option. If set to User, press
key to
display a submenu, which allows dening
Event and Link Pass/Fail and Marginal
Threshold values.
Event Settings
Event Setting menu is enabled either in Full Auto or Expert OTDR test mode.
From the Full Auto, Expert, or Real-Time test mode perform the following:
• Use Tab Keys to access the Event Settings page.
• Use arrows to highlight the desired parameter.
Navigating Through Event Setting Menu
Use arrows to toggle
between Show Pass/Fail and
Exclude Pass/Fail option.
To Next Page
Loading...
Need help?
General
