AFL M210e User Manual

20
Setup Parameters Available in Expert Mode
Event Settings
In the Expert OTDR test mode, these parameters may be set as indicated below:
Parameter Option Description
Events
Auto An Event Table is calculated for every test.
Off Event Table is not calculated.
Bi-derectional
Analysis
On For tests in End 1 > End 2 and End2 > End1 direction, an Event
Table is generated with added bi-directionally averaged data.
Off Bi-directionally averaged data is not calculated.
Macro/
Microbend
Detection
Enabled Macro/Microbend detection is On.
Disabled Macro/Microbend detection is Off.
Front Panel
Check
On
Enables OTDR to check the quality of the connection at the OTDR
front panel and provides on-screen suggestions for corrective actions
if the Front Panel connection is BAD or FAIR (see “Front Panel and
First Connector Check” on page 37 for details).
Off Disables the OTDR Front Panel connection check.
First
Connector
Check
On
Enables OTDR to check the quality of the rst connection at ber
under test and provides on-screen suggestions for corrective actions
if the First connection is BAD or FAIR (see “Front Panel and First
Connector Check” on page 37 for details).
Off Disables the First Connector check.
Event
Thresholds
Default
Set to default values (see page 23).
Press
key to view the default values.
User
Values may be adjusted within allowed limits
(see page 23).
Pass/Fail
Thresholds
Default View default values (see page 23) and turn Event Pass Thresholds
On/Off (Threshold set to default values).
User Values may be adjusted within allowed limits
(see page 23).
Last Event
Status
Show
Pass/
Fail
Show Pass/Fail indicates the last event will be included from pass/fail
determination based on pass/fail thresholds.
Exclude
Pass/
Fail
Exclude Pass/Fail indicates the last event will be excluded from pass/
fail determination based on pass/fail thresholds.

AFL M210e Specifications

General

Brand	AFL
Model	M210e
Category	Measuring Instruments
Language	English