24
OPM Test Settings
Displays the currently
selected or detected
wavelength(s).
This eld displays the
current OPM test mode:
Wave ID - receiving
wavelength ID’d light.
Tone in Hz - receiving
tone signal in Hz.
Fiber Number - user set
Use
arrows to select the Fiber parameter.
Use
arrows to increment/decrement the
Fiber number one number at a time.
Press
key to open a numerical editor, which
allows entering a ber number from 001 to
999.
Cable ID - user set
Use
arrows to select the Cable ID parameter.
Press
key to open the Results Manager,
which allows the user to make changes to the
Job Settings.
OPM Home Page Indicators
This eld indicates
mode: Live or Saved.
This eld displays test readings:
Measured Insertion Loss values in dB or measured
Power in dBm or mW.
If the power or loss is too high/low for the OPM to
measure, High/Low label is displayed in place of the
Loss or Power values.
Location and Operator
ID are user set in the Job
Settings Page.
To Next Page
Loading...
