Sensor area
When in rapid sequence mode or in fluoroscopy mode, a smaller active area
on the DR detector can be selected to get better image resolution or more
frames per second.
Different sets of sensor area sizes are available for fluoroscopy and for rapid
sequence mode. When you select a sensor area for fluoroscopy mode, an equal
or larger sensor area is automatically activated for rapid sequence mode. The
collimation is automatically adjusted to match the smallest sensor area and
applies to both modes.
Figure 159: Sensor area
Related Links
Dynamic imaging modes on page 293
222 | DR 800 | Software Console
0392C EN 20210309 1049
To Next Page
Loading...
