Mains supply
All the components of the X-ray installation must be connected to the
electrical mains by means of a socket or another multi-polar connector that
must be installed by the customer. The room of the installation must be in
compliance with the IEC/CEI or UL/CSA prescriptions in force (where
requested).
The relevant national regulations must be applied in all countries.
Nonetheless, compliance with the abovementioned standards is strongly
recommended, when they do not contradict the national regulations in force,
to ensure safety for the operator, the patient and third parties.
68 | DR 800 | Introduction
0392C EN 20210309 1049
To Next Page
Loading...
