AGFA DR 800 - Checking the automatic collimation

Checking the automatic collimation
1. Move the focal distance to 115 cm.
2. Select the second sensor area and check that the collimator automatically
sets to the selected value (30x30).
3. Vary the focal distance and check that the selected format keeps the right
value.
4. Select the third sensor area and check that the collimator automatically
sets to the selected value (20x20).
5. Vary the focal distance and check that the format remains unchanged even
if the focal distance varies.
6. Select the fourth sensor area and check that the collimator automatically
sets to the selected value (15x15).
7. Vary the focal distance and check that the format remains unchanged even
if the focal distance varies.
82 | DR 800 | Introduction
0392C EN 20210309 1049