Agilent Technologies 1260 - Changing the IP Address of an Instrument Using the Agilent Bootp Service

74 Agilent 1260 Infinity DAD and MWD User Manual
4 LAN Configuration
Automatic Configuration with BootP
Changing the IP Address of an Instrument Using the Agilent BootP
Service
Agilent BootP Service starts automatically when your PC reboots. To change
Agilent BootP Service settings, you must stop the service, make the changes,
and then restart the service.
Stopping the Agilent BootP Service
1 From the Windows control panel, select Administrative Tools > Services. The
Services screen appears.
Figure 22 Windows Services screen
2 Right-click Agilent BootP Service.
3 Select Stop.
4 Close the Services and Administrative Tools screen.