Baud Rate Selection (RS-232)
You can select one of six baud rates for RS-232 operation. The rate is set
to 9600 baud when the meter is shipped from the factory.
• Select one of the following: 300, 600, 1200, 2400, 4800, or 9600 baud
(factory setting).
• The baud rate selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
• Front Panel operation: set the baud rate under the 3: BAUD RATE
command in the I/O menu.
See also “To Set the Baud Rate,” on page 190.
• Remote operation: use the following commands to set the baud rate:
SYStem:COMMunicate:SERial:BAUD <
baud
>
If you change the baud rate over the remote interface, you may lose control
of the meter.
3
Chapter 3 Features and Functions
Remote Interface Configuration
103
To Next Page
Loading...
Need help?
General
