To Set the Baud Rate
You can select one of six baud rates for RS-232 operation. The rate is set
to 9600 baud when the meter is shipped from the factory. See also “Baud
Rate Selection,” on page 103.
On/Off
Shift < 1 Turn on the front-panel menu.
A: MEAS MENU
< < 2 Move across to the I/O MENU choice on this level.
F: I/O MENU
∨
> > 3 Move down a level and then across to the BAUD RATE command.
3: BAUD RATE
∨ 4 Move down to the “parameter” level to select the baud rate.
Use the left/right arrow keys to see the baud rate choices. Choose from
one of the following: 300, 600, 1200, 2400, 4800, or 9600 baud.
9600 BAUD
Auto/Man 5 Save the change and exit the menu.
ENTER The baud rate selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
Remote Interface: you can set or query the baud rate using the
following commands:
SYStem:COMMunicate:SERial
:BAUD <
baud
>
:BAUD?
Chapter 4 Remote Interface Reference
To Set the Baud Rate
190
To Next Page
Loading...
