Math Operation Commands
See also “Math Operations,” starting on page 74 in chapter 3.
There are two main math operations available; stats and scale, only one
of which can be enabled at a time. Stats performs mathematical
operations on a series of readings. Scale performs a mathematical
operation on each reading.
The selected math operation remains in effect until you disable it, change
functions, turn off the power, or perform a remote interface reset.
CALCulate:FUNCtion {AVERage | SCALe}
This command selects the main math function. Only one function can be
enabled at a time. [volatile memory]
CALCulate:FUNCtion?
This command queries the present math function. Returns SCAL or AVER.
CALCulate[:STATe] {OFF | ON}
This command disables or enables the selected math function.
[volatile memory]
CALCulate[:STATe]?
This command queries the state of the math function.
Returns “0” (
OFF) or “1” (ON).
Chapter 4 Remote Interface Reference
Math Operation Commands
148
To Next Page
Loading...
Need help?
General
