Command Summary
This section summarizes the SCPI (Standard Commands for
Programmable Instruments) commands available to program the meter.
Refer to the later sections in this chapter for more complete details on
each command.
Throughout this manual, the following conventions are used for SCPI
command syntax. Square brackets ( [] ) indicate optional keywords or
parameters. Braces ( {} ) enclose a list of parameters separated with a
vertical bar ( | ), use only one of the values. Triangle brackets ( <> )
indicate that you must substitute a value for the enclosed parameter.
The actual command string you send to the meter should not include
any of the conventions indicated above.
First-time SCPI users, see page 183.
4
Chapter 4 Remote Interface Reference
Command Summary
117
To Next Page
Loading...
