To Use Reading Memory
The meter can store up to 1024 readings in internal memory. The
following steps demonstrate how to store readings and retrieve them.
1 Select the function.
Select any measurement function. You can change the function at any
time during reading memory.
Single 2 Select the single trigger mode.
Notice that the Trig annunciator turns on. When reading memory is
enabled, readings are stored when you trigger the meter.
For this example, single triggering is used to store readings. You can also
use auto triggering or reading hold.
On/Off
Shift < 3 Turn on the menu.
A: MEAS MENU
< < < 4 Move across to the SYS MENU choice on this level.
E: SYS MENU
v 5 Move down to a level to the RDGS STORE command.
1: RDGS STORE
Chapter 2 Front-Panel Operation
To Use Reading Memory
50
To Next Page
Loading...
Need help?
General
