v > 6 Move down a level and then across to the “ON” choice.
ON
Auto/Man
ENTER 7 Save the change and exit the menu.
Notice that the Mem (memory) annunciator turns on to indicate that the
meter is ready to store readings. Up to 1024 readings can be stored in
first-in-first-out (FIFO) order. When memory is full, the Mem
annunciator will turn off.
Readings are preserved until you re-enable reading memory at another
time, turn off the power, or perform a remote interface reset.
Single
Single Single 8 Trigger the meter three times.
This stores three readings in memory.
Recall
Shift > 9 Use menu recall to retrieve the stored readings.
This takes you to the “SAVED RDGS” command in the SYS MENU.
2: SAVED RDGS
2
Chapter 2 Front-Panel Operation
To Use Reading Memory
51
To Next Page
Loading...
Need help?
General
