Agilent Technologies 34420A User Manual

Programming Language Selection
You can select one of two languages to program the meter from the
selected remote interface. The programming language is SCPI when
the meter is shipped from the factory.
• Select one of the following: SCPI or 181 (Keithley).
• The language selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
• There are certain restrictions to be aware of when you are selecting
the interface language (see also “Remote Interface Selection,” on
page 101). The Keithley 181 language is not supported on the RS-232
interface.
• Front Panel operation: set the programming language under the
5: LANGUAGE command in the I/O menu.
See also “To Select The Programming Language,” on page 192.
• Remote operation: use the following command to set the language:
SYStem:LANGuage <
language >
3
Chapter 3 Features and Functions
Remote Interface Configuration
105

Agilent Technologies 34420A Specifications

General

Brand	Agilent Technologies
Model	34420A
Category	Multimeter
Language	English