Agilent Technologies 34420A User Manual

To Select the Programming Language
You can select one of three language to program the meter from the
selected remote interface. The language is
SCPI when the meter is
shipped from the factory. The languge setting is stored in non-volatile
memory and does not change with power off or reset. See also
“Programming Language Selection,” on page 105.
On/Off
Shift < 1 Turn on the front-panel menu.
A: MEAS MENU
< < 2 Move across to the I/O MENU choice on this level.
F: I/O MENU
∨
< 3 Move down a level and then across to the LANGUAGE command.
5: LANGUAGE
∨ 4 Move down to the “parameter” level to select the language.
Choose from one of the following: SCPI or KEITHLEY:181
SCPI
Auto/Man 5 Save the change and turn off the menu.
ENTER The language selection is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
Remote Interface: you can set the programming language using the
following commands:
SYStem:LANGuage {SCPI | 181}
L1X
(SCPI)
L2X (Keithley 181)
Chapter 4 Remote Interface Reference
To Select the Programming Language
192

Agilent Technologies 34420A Specifications

General

Brand	Agilent Technologies
Model	34420A
Category	Multimeter
Language	English