Statistics
• After you enable statistics, the first reading that the meter takes is
stored as both the minimum and maximum value. The minimum is
replaced with any subsequent value that is less. The maximum is
replaced with any subsequent value that is greater.
• All values are stored in volatile memory; the meter clears the values
when stats is turned on, when power has been off, or after a remote
interface reset or preset.
• When enabled, the following statistics are available:
MIN minimum reading
MAX maximum reading
AVER arithmetic average of all readings
STD DEV standard deviation of all readings
PEAK – PEAK peak to peak value of minimum and maximum
COUNT the total number of readings
• Front Panel operation: Enable the statistics by pressing
the
Stats key. Read the statistics gathered in the MATH menu
under the STATS command.
After reading the stored statistics, press
Shift < (Menu On/Off) to
return to the measurement and continue taking statistics.
3
Chapter 3 Features and Functions
Math Operations
75
To Next Page
Loading...
Need help?
General
