Issue 2 - 07/00 4-73
Testing in Simulation Mode - Section 5
-2-
Select ECT. This connects the active call and the
held call to each other. aurora
Sonata
then clears
the calls between you and the other two users
and displays the main Simulate menu.
Malicious Call Identification (MCID)
This service allows the subscriber to request that the source of
an incoming call is identified and registered by the network.
-1-
For an existing connected call, display the
Supp Services menu.
-2-
Select MCID.
aurora
Sonata
displays a pop-up message to show that the MCID
request has been accepted.
îîNote
You can also test MCID after the caller has initiated clearing.
See Testing MCID during disconnection later in this section.
Call Suspend/Resume
This service allows the subscriber to temporarily suspend a
call, normally in order to move their terminal from one socket
to another on the same multi-point line. When the terminal is
connected again, the subscriber can resume the call.
To test Suspend/Resume, aurora
Sonata
must be emulating a TE.
To Next Page
Loading...
