236 Chapter 3
Mode
Distance To Fault
Mode
requirements. This mask can then be compared with the measured trace data to determine
pass/fail conditions.
Limit Trace
Selects the trace to which the currently selected limit mask (1 or 2) will be applied. The limit masks
can be applied to separate traces. Only 2 traces are available in the Stimulus Response mode
(compared to 4 traces in the Spectrum Analyzer Mode).
Segment (Center, 1st or 2nd)
Selects the
Center, 1st or, 2nd segment for limit mask 1 or 2. With each segment setting, the Limits
menu is updated to show the span and level settings available for the currently selected segment
Center Segment
Segments (Center) Sets the state of the center segment to On or Off. This key is available only when
Center has been selected with the Segments key.
Mode Stimulus / Response
Dependencies /
Couplings
The limit mask is always displayed when the center segment is
turned on; even if the trace to which it is being applied is
blanked (‘Show’ set to Off).
Preset 1
State Saved Saved in instrument state.
Range 1 | 2
Key Path
Meas Setup, Limit Masks, Limit Mask 1, Limit Mask Trace
Mode Stimulus / Response
Dependencies /
Couplings
Key menu structure is dependant on selected segment.
Preset Center
State Saved Saved in instrument state.
Range Center | 1st | 2nd
Key Path
Meas Setup, Limit Mask 1, Segment (Center, 1st or 2nd)
Mode Stimulus / Response
Notes Key is only displayed when the selected segment is Center
To Next Page
Loading...
