90 Chapter 3
Mode
Meas Off (Spectrum Analyzer) Measurement
Mode
• For security purposes
If you have turned off the display and you are in local operation, the display can be turned
back on by sending the DISPlay:ENABle ON command (neither *RST nor
SYSTem:PRESet enable the display.)
Mode SA
Remote Command :DISPlay:ENABle OFF|ON|0|1
:DISPlay:ENABle?
State Saved Not saved in instrument state
Mode Preset Not affected by *RST or SYSTem:PRESet
Factory
Default
On
Couplings DISP:ENAB OFF turns Backlight OFF and DISP:ENAB
ON turns Backlight ON. However, settings of Backlight
do not change the state of DISP:ENAB
Example DISP:ENAB OFF
Key Path
None, no front-panel control
To Next Page
Loading...
