EDIT PROGRAM - SINGLE
Page 110 S3200XL Operator’s Manual - Version 1.00
NOTE: Because the resonance control in FILTER 2 has twice the range of FILTER 1’s,
theoretically, you should set FILTER 2’s resonance to twice that of FILTER 1’s but in practice,
you will find that this is not strictly necessary. However, by setting both filter’s resonance to
maximum (15 and 30 respectively), you can create very resonant and ‘squelchy’ synth sounds,
especially synth basses.
Watch out for distortion, however, with such high resonance settings. When using high
resonance settings, you may find it necessary to switch in the -6dB pad in the
field - you may even need to back the programs output level off as well.
To Next Page
Loading...
Need help?
General
