SAVE
S3200XL Operator’s Manual - Version 1.00 Page 205
SAVE MODE
Once you have some sounds in memory that you have edited, you will no doubt want to save
them for future retrieval. Pressing SAVE gives this screen:
SELECTING FLOPPY OR HARD DISK
If the cursor is not already on the field, move the cursor to the field and
select or as appropriate using the DATA wheel.
SELECTING THE HARD DISK PARTITION
When a hard disk is formatted on the S3200XL, it is divided into sections called partitions (see
later for details on formatting disks). This makes disk management slightly easier. Depending
on the number of partitions on your disk, the partition is shown as a letter A - ? next to the
HARD-: field. You can move the cursor one position to the right to select the partition you wish
to save to. You will see something like this screen:
Use the DATA wheel to make your selection.
SELECTING THE HARD DISK VOLUME
As well as being divided into partitions, each partition is divided into volumes. The volume is
selected in the field (in the above example, it shows that the volume is not named - see
below for details on naming volumes). To select the volume, move the cursor to the field
and select using the DATA wheel.
SELECTING THE TYPE OF SAVE
The field allows you to select what it is you will save to disk (be it floppy or
hard disk). To change the type of save you wish to perform, move the cursor to the
field:
The options are:
ENTIRE VOLUME This will save the entire contents of the memory to disk. This
will include all programs, samples, the multi and effects file .
To Next Page
Loading...
Need help?
General
