EDIT PROGRAM - SINGLE
S3200XL Operator’s Manual - Version 1.00 Page 61
NAMING PROGRAMS - COPYING AND RENAMING
If you have already recorded your own samples, then this procedure should be familiar as it
follows the same conventions.
To copy or rename a program, press the NAME key - this turns the front panel keys into letter
entry keys and you may type in a name of up to 12 characters (upper case only). The +/< and
-/> keys on the numeric keypad may be used to input backspace and spaces respectively.
When naming, you will see this prompt:
Pressing the NAME key again switches the numeric keypad from letters to numbers and you
will receive this prompt:
You may press NAME again to access the numeric keypad’s letters. When in the ‘numbers’
mode, the +/< and -/> keys input ‘+’ and ‘-’ to a name. Pressing NAME again reverts you to
entering letters from the numeric keypad.
Alternatively, in conjunction with the CURSOR keys which can be used to move the cursor
around within the name, you can use the DATA control to scroll through characters.
When you have entered your name, press ENT and you will get this prompt:
Pressing will copy the original program - use this to create a new program.
If the program name is an existing one, the boxed area in the bottom right of the screen will
show:
You will receive the following prompt:
You must enter a unique new name.
Pressing will simply rename the currently selected program with the name just entered.
If the name exists, you will be prompted as above and you must re-enter a unique name.
Pressing will exit the naming process altogether with no action taking place. Should
you press this by mistake, you will see that the boxed area in the lower right of the screen still
retains the new name you entered so press NAME immediately followed by ENT and make
your choice again.
To Next Page
Loading...
Need help?
General
