GLOBAL
Page 278 S3200XL Operator’s Manual - Version 1.00
RESTORING TAKES BACK FROM DAT TO DISK
The take restore functions are found in the DREC page on F7 - . I.e:
Pressing this gives this screen display:
This page looks very much like the normal record page except that you have lost the threshold
field. To perform a restore of either a single take or all takes, line the DAT up to the appropriate
point and press F8 - on the S3200XL. You will receive the following message:
indicating that any takes currently on disk that have the same name as those backed up on
DAT will be overwritten and replaced with those from DAT. Press OK or EXIT as appropriate.
IMPORTANT NOTE:
PRESSING ‘OK’ WILL IRREVOCABLY ERASE THOSE TAKES
THAT HAVE THE SAME NAME.
BE VERY CAREFUL IN YOUR SELECTION
Immediately after you press OK, the display will show:
This indicates that the S3200XL is receiving the digital signal through the digital interface. You
should now start your DAT machine.
If the display shows WAITING FOR CARRIER, this indicates that the correct digital connection
has not been made. Please check your connections and also please check the settings of the
digital interface in the RECORD SET-UP in SAMPLE. You may press F8 - ABORT - to exit this
screen.
To Next Page
Loading...
Need help?
General
