MULTI MODE
S3200XL Operator’s Manual - Version 1.00 Page 45
NAMING A MULTI
You may wish to name the multi file to something more suitable. Simply press the NAME key
and enter a name of up to 12 characters from the front panel keys. You will receive the usual
naming prompts:
Pressing the NAME key again switches the numeric keypad from letters to numbers and you
will receive this prompt:
You may press NAME again to access the numeric keypad’s letters. When in the ‘numbers’
mode, the +/< and -/> keys input ‘+’ and “-’ to a name. Pressing NAME again reverts you to
entering letters from the numeric keypad.
Alternatively, in conjunction with the CURSOR keys which can be used to move the cursor
around within the name, you can use the DATA control to scroll through characters.
Once you have completed the name, press ENT/PLAY to finish the naming process.
NOTE: Because only one MULTI can exist in memory at any one time, you cannot copy the
multi file, only rename it. As such, the COPY REN EXIT prompt we have seen elsewhere is not
shown.
SAVING A MULTI
You may save a multi to disk and this will save the multi and all its associated programs very
simply in the SAVE mode. You may then load this multi (and its associated programs) with one
simple operation in the LOAD mode. Please see SAVE and LOAD for details on this.
LOADING A MULTI
To load a MULTI, press LOAD and select MULTI+PROGS+SAMPS as the type of load. Now
move the cursor to the multi-file stored on the floppy disk/hard disk volume and press F8
and/or F7. This will load the selected multi and any programs associated with it plus the
samples used in those programs.
To Next Page
Loading...
Need help?
General
