SINGLE MODE
S3200XL Operator’s Manual - Version 1.00 Page 31
LOADING FROM HARD DISK
If you have a hard disk of any description connected via SCSI for loading sounds, you will
receive the following display when F5 is pressed:
This is almost the same as for floppy except that you can see it tells you that it is a hard disk.
You may select from different volumes by moving the cursor to the field and scrolling
through the volumes on the disk. By moving the cursor to where it says ‘ ’ after , you
may select different partitions to choose other volumes. Loading is done in the manner
described above - press to load the entire volume and to load a particular program
and its associated samples.
NOTE: There is more to using a hard disk than that, unfortunately, such as matching SCSI
ID’s, formatting, etc.. For details on using the S3200XL with a hard disk, please refer to the
section HARD DISK CONTROL in the DISK section.
Other disk operations, like saving and formatting disks, are performed in the DISK mode, not
from this page. This page is intended purely for quick access to loading from disk.
To Next Page
Loading...
Need help?
General
