EDIT SAMPLE
Page 130 S3200XL Operator’s Manual - Version 1.00
NAMING SAMPLES - COPYING AND RENAMING
There are times when you want to rename a sample or copy it. You may want to rename it just to
give it a more meaningful name. You may want to copy a sample so that you can work on it with
no harm coming to the original.
To copy or rename a sample, press the NAME key - this turns the front panel keys into letter
entry keys and you may type in a name of up to 12 characters (upper case only). The +/< and
-/> keys input backspace and spaces accordingly and the MARK and JUMP keys input ‘#’ and
‘.’ respectively. You will see this prompt:
Pressing the NAME key again switches the numeric keypad from letters to numbers and you
will receive this prompt:
You may press NAME again to access the numeric keypad’s letters. When in the ‘numbers’
mode, the +/< and -/> keys input ‘+’ and ‘-’ to a name. Pressing NAME again reverts you to
entering letters from the numeric keypad.
Alternatively, in conjunction with the CURSOR keys which can be used to move the cursor
around within the name, you can use the DATA control to scroll through characters.
When you have entered your name, press ENT and you will get this prompt:
Pressing will copy the original sample. If the sample name is an existing one, the boxed
area to the top left of the screen will show something like:
You will receive the following prompt:
You must enter a unique new name.
Pressing will simply rename the currently selected sample with the name just entered. If
the name exists, you will be prompted as above and you must re-enter a unique name.
Pressing will exit the naming process altogether with no action taking place. Should
you press this by mistake, you will see that the boxed area to left of the screen still retains the
new name you entered so press NAME immediately followed by ENT and make your choice
again.
To Next Page
Loading...
Need help?
General
