LOAD
Page 218 S3200XL Operator’s Manual - Version 1.00
SELECTING THE HARD DISK VOLUME
As well as being divided into partitions, each partition is divided into volumes. The volume is
selected in the field (in the above example, it shows that the volume is not named - see
later for details on naming volumes). To select the volume, move the cursor to the field
and select using the DATA wheel.
SELECTING THE TYPE OF LOAD
The field allows you to select what it is you will load from disk (be it floppy or
hard disk). To change the type of load you wish to perform, move the cursor to the
field:
The options are:
ENTIRE VOLUME This will load the entire contents of the disk to memory. This
will include all programs, samples, the multi and effects file.
ALL PROGS+SAMPLES This will load all programs and samples only. The MULTI and
any effects files will be ignored and not loaded.
ALL PROGRAMS ONLY This will load all the programs on disk but will not load the
samples associated with them.
ALL SAMPLES This will load all the samples currently on disk
CURSOR PROG+SAMPLES This will load the selected program and its associated samples
only.
CURSOR ITEM ONLY This will load the selected individual item be it a program, a
sample or a multi. You may also load effects files. You may also
load ME-35T Drum settings, D-D SONG files (called TL’s - take
lists) and Qlists
OPERATING SYSTEM This will load any operating system that may be on the disk.
MULTI+PROGS+SAMPS This will load the selected multi plus its associated programs
and their associated samples. It will also load the effects file.
NOTE: If you have programs in memory that you call up in the multi via program change
commands in the sequence (for example, you use MIDI program change to change the
acoustic piano sound used in the verse to an electric piano sound in the chorus), those
programs which are not currently in the multi at the time of saving will not be loaded. Your
attention is brought to this as you may load a multi and then wonder why it is not playing back
correctly . If you do have programs in memory for selection via the sequencer’s MIDI program
change, use LOAD ENTIRE VOLUME.
To Next Page
Loading...
Need help?
General
