SAMPLE
Page 122 S3200XL Operator’s Manual - Version 1.00
If you are not sure how long to set this, it is best to set it longer than you think
you need. Samples can always be trimmed and edited later.
Once you have set the parameters as you like on this setup page, you don’t have to worry
about them for the rest of the sampling session as these are retained from sample to sample as
you record them.
IMPORTANT NOTE - SAVING RECORD PARAMETERS TO DISK
It is possible to save your own set of record parameters to disk. By setting the parameters as
you need them, save the operating system to floppy disk (go to SAVE, move the cursor to
‘type of load:’ and select OPERATING SYSTEM. Now press WIPE and/or GO). This will save
your personal record parameters to disk. From now on, when you boot up with this floppy in
the drive, these record parameters will always be set for you. If you have a particular way of
working, this may be invaluable and a great time saver.
If you have several different ways of working, you might like to save different record set-up
parameters to different disks and use the appropriate operating system as and when you need
it. You will note that you cannot save several operating systems on one disk - you will need a
separate disk for each system you save. Please refer to the SAVE section for more information
on saving files.
To Next Page
Loading...
Need help?
General
