EFFECTS EDIT
S3200XL Operator’s Manual - Version 1.00 Page 201
Another way to picture the is as follows:
REV > MOD/ECHO MOD/ECHO > REV
–50
00 +50
At values of -01 to -50, more of the mod/echo section is fed to the reverb and setting of +01 to
+50, more of the reverb is fed into the mod/echo section.
As you can see, the offers a great deal of flexibility in the way the effects chain
is laid out with just one simple control. Normally, you will probably use a positive setting (i.e.
flange followed by reverb) and +25 is a good setting for most occasions but, to change this
direction (to flange the reverb, for example), simply set a negative value.
NOTE: Of course, the PATH CONTROL & OUTPUTS screen only applies to the multi-effects
channels FX1 and FX2.
When editing RV3 or RV4, the OUTPUT screen looks like this:
You only have access to the level and pan/balance of the reverb, of course.
To Next Page
Loading...
Need help?
General
