Service Egress and Ingress QoS Policies
Quality of Service Guide 251
Description This command enables the context in which common properties for dynamic-policers can be
configured. Dynamic policers are instantiated and terminated on demand due to an action request
submitted by the policy server (for example via Gx interface). The actions types behind dynamic
policers are typically related to rate-limiting or volume monitoring. The dynamic-policers can be
instantiated on demand at any time during the lifetime of the sla-profile instance.
Default none
range
Syntax range start-entry policer-id count count
no range
Context config>qos>sap-egress
config>qos>sap-ingress
Description This command defines the range of ids for dynamic policers that are created via Gx interface. The no
version of the command disables creation of dynamic policers via Gx interface, resulting in a Gx rule
instantiation failure.
The no for of the command reverts to the default.
Default no range
Parameters start-entry policer-id — Specifies the lowest entry in the range.
Values 1 to 63
count count — Specifies the number of entries in the range.
Values 1 to 63
ethernet-ctag
Syntax [no] ethernet-ctag
Context config>qos>sap-egress
Description This command specifies that the top customer tag should be used for egress reclassification based on
dot1p criteria. This command applies to all dot1p criteria configured in a given SAP egress QoS policy.
The no form of this command means that a service delimiting tag will be used for egress
reclassification based on dot1p criteria.
Default no ethernet-ctag
To Next Page
Loading...
