1 Publication 1756-UM050A-EN-P - December 2001
Chapter
2
Installing the 1756-ENBT Module
What This Chapter Contains
This chapter describes how to physically install the module in the
ControlLogix chassis and connect it to the network. The following
table describes what this chapter contains and where to find specific
information.
For information about See page
Identifying Module Components 2-2
Preparing the Chassis for Module Installation 2-2
Determining Module Slot Location 2-3
Installing the Module in the Chassis 2-4
Removing or Replacing the Module (when applicable) 2-5
Installing or Removing the Module Under Power 2-6
Wiring the RJ45 Connector 2-6
Connecting the Module to the Network 2-7
Applying Chassis Power 2-8
Checking Power Supply and Module Status 2-8
AB Parts
To Next Page
Loading...
Need help?
General
