EasyManuals Logo

Allen-Bradley ControlLogix 1756-ENBT User Manual

Allen-Bradley ControlLogix 1756-ENBT
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
Publication 1756-UM050A-EN-P - December 2001
6-2 Using Analog I/O with Direct Connection
Set Up the Hardware
Change the system configuration of the previous chapter to that
shown below, adding an analog output module to the remote chassis
in slot 3. For this example, we used a 1756-OF8 analog output
module.
Note that in the example application, the Logix5550 controller,
I/O modules, and the 1756-ENBT modules are in the slots
shown above.
Verify that the IP addresses for the 1756-ENBT modules and
personal computer are correct.
Verify that all wiring and cabling is properly connected.
Make sure you have your communication driver (e.g.,
AB_ETH-1) configured in RSLinx as described in Appendix C.
Data
Slot 0 1 Slot 0 1 2 3
Switch
Programming
130.130.130.1
Terminal
Local
Chassis
Remote
Chassis
Logix5550
Controller
1756-ENBT
130.130.130.2
1756-ENBT
130.130.130.3
1756-IB16I
Digital Input
1756-OB16I
Digital Output
1756-OF8
Analog Output
1756-IB16I
Digital Input
1756-ENBT
130.130.130.2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley ControlLogix 1756-ENBT and is the answer not in the manual?

Allen-Bradley ControlLogix 1756-ENBT Specifications

General IconGeneral
BrandAllen-Bradley
ModelControlLogix 1756-ENBT
CategoryControl Unit
LanguageEnglish

Related product manuals