Display Description Cause/Corrective Action
E dr
Drain Error If the control has the drain error enabled the control will enter Ma-
chine Error Mode when the water height is not below the empty lev-
el, after attempting to drain for the programmable time (default 15
minutes). In the event of a drain error, the control will turn off all
outputs and sounds.
The control sounds an alarm tone for 15 seconds.
To clear the error, disconnect and then reconnect power to the ma-
chine.
E FL
Fill Error This error may be programmed on or off. The machine does not
reach the programmed fill level within 30 minutes. The machine en-
ters Door Unlocking Mode and drains for 90 seconds.
The control sounds an alarm tone for 15 seconds.
To clear the error, disconnect and then reconnect power to the ma-
chine.
E nFLo
No Water Flow Error If the control does not reach a water level of 4 inches within the pro-
grammed time it may mean the hose to the pressure sensor has a
leak or no water is flowing into the machine. The control enters Ma-
chine Error Mode. The control drains for 90 seconds and then turns
off all outputs.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
E oF
Overflow Error The control senses an unsafe high water level is detected in the ma-
chine and water is unable to drain.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
E PS
Pressure Sensor Error The control does not detect a valid water level sensor input for thirty
(30) seconds, or the Max (Overflow) Fill Level in the control is set
to 0 while in Run Mode, Factory Test Cycle, or Overflow Mode. The
machine enters the Door Unlocking Mode and attempts to drain for
30 seconds.
The control sounds an alarm tone for 15 seconds.
To clear this error either power down the machine or simultaneous-
ly press the Normal and Warm keypads.
E Sd
Slow Drain Error (right most deci-
mal point)
If a slow drain is detected in the Drain step of a running cycle, the
control will light the right-most decimal point. The decimal point
will remain illuminated after the slow drain error display has ex-
pired. The decimal point can be cleared by pressing the START (en-
ter) keypad 3 times in a period of 5 seconds, or by cycling the power
to the machine.
Table 37 continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
159 Part No. F8615401ENR4
To Next Page
