IE340 Series Installation Guide
110
Monitoring the Initialization Process
It takes several minutes for the switch to initialize its operating system and
load the default configuration. You can monitor the bootup sequence by
connecting a terminal or computer with a terminal emulator program to the
Console port on the front panel. The parameter settings for the Console
port are found in “Starting a Local Management Session” on page 113.
Figure 52 here and Figure 53 on page 111 contain the initialization
messages.
After monitoring the initialization process, go to “Starting a Local
Management Session” on page 113.
Figure 52. Initialization Messages
Verifying release... OK
Booting...
Uncompressing Linux... done, booting the kernel.
Starting base/first... [ OK ]
Mounting virtual filesystems... [ OK ]
Allied Telesis Inc.
AlliedWare Plus (TM) v0.0.0
Current release filename: IE340-main-20190213-1.rel
Built: Tue Feb 12 22:58:46 UTC 2019
Mounting static filesystems... [ OK ]
Checking flash filesystem... [ OK ]
Mounting flash filesystem... [ OK ]
Checking for last gasp debug output... [ OK ]
Initializing random number generator... [ OK ]
Starting base/hwrandom... [ OK ]
Starting base/dbus... [ OK ]
Starting base/linux... [ OK ]
Starting base/syslog... [ OK ]
Starting base/loopback... [ OK ]
Starting base/poe_done... [ OK ]
Received event syslog.done
Starting base/modules... [ OK ]
Received event module.done
tarting base/reboot-stability [ OK ]
Checking system reboot stability [ OK ]
Starting base/apteryx... [ OK ]
Starting base/debugevent... [ OK ]