IE340 Series Installation Guide
80
Here are the tools and material required for installing the switch on a
concrete wall:
Two wall brackets (included with the switch)
Four bracket screws (included with the switch)
Four wall screws (not provided)
Cross-head screwdriver (not provided)
Drill and 1/4” carbide drill bit (not provided)
Four anchors and screws for attaching the switch to the wall (not
provided). The diameter of the screw holes in the wall brackets is
4.5 mm (0.17 in.).
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch in a table.
2. With a Phillips-head screwdriver, remove the four screws holding the
pre-installed DIN rail bracket, and remove the bracket. Refer to Figure
24 on page 76.
3. Install the two brackets that come with the switch to the back panel of
the unit. Refer to Figure 25 on page 77.
4. Have a person hold the switch on the concrete wall at the selected
location for the device while you use a pencil or pen to mark the wall
with the locations of the four screw holes in the two wall brackets.
Refer to Figure 27 on page 81.
Please follow these guidelines as you position the switch on the wall:
The switch must be oriented as shown in Figure 27. You may not
install the switch horizontally or upside-down.
Be sure to leave sufficient space from other devices or walls to
allow for adequate air circulation around and through the cooling
fins. Refer to “Reviewing Site Requirements” on page 59 for further
information.
To Next Page
Loading...
Need help?
General
