Product description
21
0000010038-003- GB
Product description
Residual risk:
Even when the machine is operated in accordance with its intended use and all
pertinent safety regulations, the following residual risks may be encountered
because of design changes caused by the intended use in question:
• Contact with the main saw blade and the scoring blade in the cutting area,
in particular when the saw blade is tilted in the -45° position and the protec-
tion hood is not correctly adjusted.
• Contact with the main saw blade and the scoring blade from beneath the
table level when the sliding table is pushed fully forward or pulled fully
back.
• Kick-back of workpiece or workpiece parts.
• Individual teeth spinning off tungsten carbide tipped blades.
• Breakage and ejection of the saw blade.
• Crushing at the manual or motor-driven sliding table.
• Crushing between the motor-driven tilt movement of the saw blade and the
rip fence or workpieces lying in the tilting area.
• Contact with live parts when the electrical installation area is open.
• Damage to hearing as a result of working for long periods of time without
hearing protection
• Emission of health-endangering dust from operation without extraction.
• Wear suitable gloves due to the risk of cuts when handling saw blades,
grooving tools and pushing the wood into the machine, as well as during
maintenance work.
• Do not remove chips while the saw blades are turning due to the risk of
injuries.
• Do not use the machine unless all protective devices/guards required for
processing have been installed and are in perfect condition due to the risk
of injuries.
Warning!
Avoid the potential dangers posed by these remaining risks by paying
increased attention when setting up, operating and servicing the
machine!
Always adhere to the specified working positions when operating the
machine.
To Next Page
