Product description
29
0000010038-003- GB
Product description
3.7 Safety information
3.7.1 Operational safety
The operation of woodworking machines with a manual feed involves a high
risk in the event of incorrect handling. Therefore always observe the safety in-
formation that is summarised in this chapter as well as government and other
industrial safety regulations (e.g. accident prevention regulations)!
• Never operate the machine without the protective devices intended for the
specific work cycle (also refer to “Working safely with the sliding table saw
– working examples”), and do not make any changes that could impair
safety.
• Before all work, make sure that the protective and working devices are
securely fitted and are not damaged.
• Before changing a tool, rectifying any faults and carrying out repairs, make
sure that the machine cannot be turned on accidentally, for example by
padlocking the main switch.
• Only use correctly sharpened tools designed to conform with the require-
ments of the European standard EN 847-1:2005+A1:2007.
• When grooving with milling tools, only use milling tools for manual feeding
with a groove width less than or equal to 20 mm (5 mm for machines with
the option "Saw blade tilting to both sides"), marked with MAN according to
the European standard EN 847-1:2005+A1:2007.
• Only fit saw blades with the dimensions described in the technical data.
The diameter of the mounting hole must always measure 30 mm. Loose
intermediate rings are not allowed to be used.
• Select the rotational speed so that the maximum permissible rotational
speed specified for the tool is not exceeded when using tungsten carbide
tipped saw blades or grooving cutters.
• HSS saw blades and cracked or deformed saw blades may not be used.
• Always wear tight-fitting work clothes and do not wear rings, bracelets or
watches.
• Make sure that the workplace is uncluttered, slip-proof and well lit.
• Do not cut workpieces that are too large or too small for the machine to
handle.
• When working at the machine, always stand to the side of the saw blade
outside a possible kick-back area.
i
Note!
Ensure that the operators are suitably trained in the use, setting and ope-
ration of the machine!
To Next Page
Loading...
