Transport, siting and installation
40
Transport, siting and installation
0000010038-003- GB
5 Transport, siting and installation
5.1 Transport
When transporting the sliding table saw by elevating truck or fork lift truck (forks
only with unchangeable length), only lift the machine up slightly and secure it
against tipping!
Packaging
The type of packaging depends on the type of transport. Unless otherwise con-
tractually agreed, the packaging corresponds to the HPE guidelines establis-
hed by Bundesverband Holzmittel, Paletten, Exportverpackungen e.V. (the
German Association for Wooden Materials, Pellets, Export Packaging) and the
VDMA.Observe the symbols on the outside of the packaging!
Degree of dismantling
The degree of dismantling of the sliding table saw depends on the transport
conditions and the options supplied with the machine.The sliding table is al-
ways shipped dismantled into several installation assemblies.
Sensitivity
Particular care must be taken when transporting the sliding table saw in order
to avoid damage from force or poor loading and unloading.Knocks and conden-
sation due to extreme temperature fluctuations must be avoided during trans-
port.
Intermediate storage
If the sliding table saw or its assemblies are not installed immediately after deli-
very, make sure that they are stored in a protected location.They must be cor-
rectly covered to prevent any ingress of dust or moisture.Bare, non-surface-
treated parts of the sliding table saw are protected with a conserving agent
which will protect them for approx. 1 year. Reconservation is necessary if sto-
rage is to last longer than this period.
To Next Page
Loading...
