Transport, siting and installation
82
Transport, siting and installation
0000010038-003- GB
5.4.7 0° setting of the saw blade
Check:
• Set the tilt adjustment to 0°.
• Position 2 strips (approx. 100 mm wide) vertically in front of the crosscut
fence, cut in this position and butt the cut surfaces against each other.
• If the setting is correct, the cut surfaces should be parallel, i.e. no gap can
be seen between the cut surfaces.
Setting:
Recalibrate the machine if a gap is detectable!
Fig. 5-48 Cutting a test piece
Fig. 5-49 Checking the 0° -setting
To Next Page
Loading...
