Operating
176
Operating
0000010038-003- GB
6.6.12 Coolant spray device
To improve the cutting quality, we recommend the use of a coolant spray de-
vice for plastics with a low melting point and for certain light metal alloys, espe-
cially in conjunction with the infinitely variable speed adjustment.
A sensor is fitted in the front table strip to detect the workpiece. It will interrupt
the coolant supply when not obstructed by a workpiece.
Fig. 6-102 Coolant spray device
i
Note!
Separate instructions are enclosed for the selected option Coolant
spray device.
To Next Page
Loading...
