Product description
27
0000010038-003- GB
Product description
3.5.2 Dust
The dust emission values – measured in accordance with the “Principles for
Testing Dust Emission (Concentration Parameters) from Woodworking Machi-
nes” issued by the German trade association's technical committee for wood –
are below 2 mg/m
3
.
When the machine is attached to a correctly functioning extraction system with
an air speed of at least 20 m/s (measured after joining the two extraction con-
nections) you can assume it is and will stay compliant with the technical refe-
rence concentration (TRK) limit for wood dust that is in force in Germany.
The machines are tested concerning wood dust in accordance with the BGI
739-1. The machines bear the DGUV mark with the additional wood dust mark
"holzstaubgeprüft". Consequently, a company operating the machine in Ger-
many is exempt from the obligation to perform measurements at the workplace
in accordance with TRGS 553.
3.5.3 Electromagnetic compatibility
EMC (Electromagnetic Compatibility) is the ability of an electrical device to
function in its electromagnetic environment without disruptively influencing this
environment, which also includes other devices, or being disturbed by it.
The machine complies with the requirements set out in the European electro-
magnetic compatibility directive 2004/108/EC (EMC directive).
i
Note!
Metal dust does not usually occur when cutting aluminium.
To Next Page
Loading...
