Product description
31
0000010038-003- GB
Product description
• Regular cleaning of the machine and, in particular, the main table, sliding
table and guides (e.g. rip fence) is an important safety factor. Before star-
ting this work, make sure that the machine cannot be switched on uninten-
tionally.
• Prior to cutting aluminium, thoroughly clean the machine and remove all
remaining chips and dust to prevent ignition of remaining chips/dust.
• The sawdust generated during cutting not only impairs visibility but is also
partially hazardous to health. Therefore, the machine must be connected to
a chip extraction system with both extraction sockets. The minimum air
speed at the lower extraction socket must be at least 20 m/s. When the
machine is switched on, the extraction system must switch on at the same
time.
Warning!
Always use a deflector wedge fastened to the table top when small waste
pieces are produced during cutting that could be kicked out by the saw
blade.
Fig. 3-2 Deflector wedge
To Next Page
Loading...
