Transport, siting and installation
50
Transport, siting and installation
0000010038-003- GB
Assembly steps:
• Carefully push the rip fence onto the round bar
• Place the TPV onto the brackets on the table top and insert the fastening
screws of the support arms into the holes on the table top face end.
• Loosely secure to the table top with two M10 nuts and U-shaped washers
• Screw-fit the TPV to the aluminium brackets (6)
• Tighten the M10 nuts.
• If necessary, correct the alignment and flushness by readjusting the sup-
port screws (4).
To Next Page
Loading...
