Transport, siting and installation
74
Transport, siting and installation
0000010038-003- GB
i
Note!
Observe the following:
• Make sure that the extraction system is switched on together with the
machine. For this, you can use the existing potential-free contact
(POT - refer to circuit diagram) or a current transformer installed in
the supply line.
• When using spray device (SPRAY), make sure that you use a suita-
ble moisture extraction system in order to avoid faults.
• Check the function of the extraction system at regular intervals!
• A spark-extinguishing system should be installed as a precaution to
prevent fires and explosions in filter systems, silos and other produc-
tion environments.
• Ensure that the extraction system is suitable for extracting aluminium
chips!
• Always collect wood, aluminium and plastic chips separately!
• Prior to cutting aluminium, thoroughly clean the machine and remove
all remaining dust and chips!
To Next Page
Loading...
