ALTUS Nexto NX3004 - Page 198

4. Configuration
190
o PLC ID – Informs the PLC identification in the redundancy. Possible information:
 CPA
 CPB
o REMOTE STATE – Informs the state of the remote redundant PLC. Possible states:
 ACTIVE
 STANDBY
 INACTIVE
 NOT CONFIG.
 STARTING
 UNAVAILABLE
o PROJ. SYNC. – Informs if the synchronization of the projects is enabled
o CONNECTED
o NOT CONNEC.
o DISABLED
o START SYNC.
o SYNCHRONIZED
 Access to the Memory card data:
o MEMCARD > CPU – Transference of the memory card project to the CPU
o CPU > MEMCARD – Transference of the CPU project to the memory card
o FORMAT – Formats the card to the FAT32 files system
Figure 4-92 describes an example of how to operate the Nexto CPUs menu through the contrast
adjust menu procedure from the Status screen. Besides to make the configuration easy, it is possible
to identify all screen levels, the touch type, to navigate through them and to modify other parameters
as language and the Memory Card, using the same access logic. The short touch shows the contrast is
being incremented (clearer) and in the next touch after its maximum value, it returns to the minimum
value (less clear). The long touch shows the confirmation of the desired contrast and its return to the
previous level.