Ammann Rammax 1515-M - Page 88

88
Rammax 1515-M/-MC/-MI/-MCI
Index: a; Issued 08/2010
Danger of re or explosions!
Hydraulic oil is inammable and can ignite easily. Oil soaked
cloths and puddles of oil can ignite.
Therefore:
Do not smoke when working on the hydraulic system.
Avoid open ames and sparks.
Do not weld on the hydraulic system or in its vicinity.
Dispose of the oil soaked cloths in the special containers.
►
►
►
►
Release the plug on the underside of the hydraulic tank.
Remove the lid of the hydraulic oil tank to allow air to ow
into the hydraulic oil tank. Allow the hydraulic oil tank to
drain completely.
Close the discharge port again with the plug and a new
gasket.
The suction lter is located in the hydraulic oil tank (Fig. MW10).
To reach it, you need to remove the battery, the battery holder
and the air lter.
Fig. MW10 Suction lter
Disconnect the battery and remove it.
Pull off the air lter hoses.
Remove the cable connectors.
Remove the screws to the battery holder and remove the
entire battery holder.







Maintaining the Machine