Chapter 3 Measurement
3-62
Level Offset
■
Summary
Sets the level adjustment coefficient of the Noise signal output.
This setting is enabled when Waveform is set to Noise.
■
Setting range
–20.0 to 20.0 dB
Offset
■
Summary
Enables/disables the offset function of the Noise signal output.
The setting is available when Waveform is set to Noise.
■
Options
On Enables the offset function of Noise signal
output.
Off Disables the offset function of Noise signal
output.
G.227 Filter
■
Summary
Enables/disables the pseudo voice filter (G.227).
This setting is enabled when Waveform is set to Noise.
■
Options
On Enables the pseudo voice filter (G.227).
Off Disables the pseudo voice filter (G.227).
Code
■
Summary
Sets the DTMF signal code.
This setting is enabled when Waveform is set to DTMF.
■
Setting range
0 to 9, A to D, *, #
(Selects one from the above.)
Level
■
Summary
Sets the DTMF signal output level.
This setting is enabled when Waveform is set to DTMF.
■
Setting range
When Output Type is Bal.:
0.001 to 3.000 Vp
When Output Type is Unbal.:
0.001 to 1.500 Vp
To Next Page
Loading...
